Led Decoder v.2.0 power supply
Verfasst: So 5. Apr 2020, 12:48
I have a Marklin CS1 and Booster 6017. In a part of my layout three Viessmann light signals (AUS+VOR) are connected to the booster through a Marklin 72090 metal distributor.
Only one at a time works well, the other two do not receive any digital command and simply stay lit.
If I disconnect two signals (no matter which ones) the third works well.
I have tried to connect the 72090 distributor directly to the CS1: all the three signals work well at the same time.
I have then tried to use the booster but with a wire thicker than standard Marklin cables: all the three signals work well at the same time.
What is the exact requirement of the led decoder v. 2.0? How should I safely and properly connect them? (I have other parts of the layout to be served, with more signals)
Thanks
Andrea
Only one at a time works well, the other two do not receive any digital command and simply stay lit.
If I disconnect two signals (no matter which ones) the third works well.
I have tried to connect the 72090 distributor directly to the CS1: all the three signals work well at the same time.
I have then tried to use the booster but with a wire thicker than standard Marklin cables: all the three signals work well at the same time.
What is the exact requirement of the led decoder v. 2.0? How should I safely and properly connect them? (I have other parts of the layout to be served, with more signals)
Thanks
Andrea